DIY AURATONE DRIVER

0 Comments

You are commenting using your Facebook account. Started by erikb Brewery. I made them half an inch wider at the front but kept the internal volume the same, using 0. For the enclosure, my idea was pretty straightforward: Is there a anti-magnet glued on the back like modern Auratones?

Uploader: Shagar
Date Added: 10 March 2006
File Size: 59.3 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 46310
Price: Free* [*Free Regsitration Required]

My drawing in real-world, striking similarity. You are commenting using your Twitter account. Monacor or Visaton are probably your best suggestion, you have the Thiele Small info for the speaker so go for the best match to that.

DIY Auratone Complete! | Here is my completed Auratone DIY b… | Flickr

On my monitors djy sounded fine but on lesser speakers it was too low. Started by Sender Drawing Board. Majestic12 on February 12, Find something Search for: I kind of picked up the bad habit of directly modifying.

Thanks Guys, As they say, “necessity is the mother of invention”.

Sorry, your blog cannot share posts by email. February 16, Solid color it is then, and why not go overboard while at it! Material costs for these speakers added up to about 40 eur. Warpie, This is all you need: My initial thought was to use recycled particle board for the panels, but as I had just about the right amount of suitable pine planks I went with those instead.

  C770 AUDIO DRIVER DOWNLOAD

Had the panel material been less thick, the terminals would have sort of slotted in over the inner side, when driver is inserted at an angle. Fill in your details below or click an icon to log in: Will definitely make use of what I learned on the topic later on: You are commenting using your Facebook account.

Davetone mixcubes

No better suggestions than knowing someone in UK who can buy and ship a pair for you. I used the wadding from an old duvet!

As you can see from the above, I had to anyway use particle board for the rear panel. Email required Address never made public. A bit of digging turned up a lot of references to the Panasonic a11ecf driver as ddiy good candidate, and likely the actual driver used in the last generation of original auratones.

Is there a anti-magnet glued on the back like modern Auratones? A slot for the terminal and paint blobs removed, both chiselled using a drill bit. I joined it all together with glue and panel pins, but I drilled the wood or board the pins pass through first not the lower part the pins bite intopunch just below surface then fill.

  LITE-ON LH-20A1L VISTA DRIVER

Davetone mixcubes | My Diy Blog

Hi Warpie, I used chipboard because of the original so it might have similar resonance, but the panels are so small it may not matter anyway. September 04, Post was not sent – check your email addresses! Hi, do you know any source for the loudspeaker you have used, outside of the UK?

Just for fun I made them look old with some varnish and stuck a label on them! This was a combination of dried up paint blobs, cables and panel thickness: Doesn’t look very complicated but I have zero experience in wood construction If you gradually up the frequency of a shelving bass boost so it sounds right on these, it also sounds right on the bigger monitors only deeper.

Test assembly, front panel.

Test assembly, rear panel.